You have a bathtub in your home. It does sustain dirt from time to time. This calls for regular and thorough cleaning. To be able to do a good job, you no doubt must know how to go about the issue. Our step-by-step discussions below endeavor to provide this guidance.
How to clean a bathtub?
#1: What is the fastest way to clean a dirty bathtub?
Some five steps will let you clean your dirty bathtub faster. These are:
Step I: Prepare the bathroom accordingly
Start by preparing the bathroom appropriately. A typical bathroom contains a water closet, sink, shower area, and of course the bathtub itself. Preparing the bathroom entails sealing out the other areas and leaving the tub alone. This entails the use of newspapers and masking tapes to cover the said items.
Step II: Wet the whole tub
After sealing out those parts of a bathroom that you won’t clean, take a step now to wet the entire bathtub. Sprinkle a small quantity of the cleanser on the tub at the location that is farthest from the drains. Apply more cleansers if the area is too dirty and incapable of becoming cleaner using the normal approaches.
Step III: Spread the cleanser
Spread the cleanser from this point going forward. To do this, you will require the intervention of a damp sponge. Maintain some evenness and consistency as you do so. Leave the cleanser intact for quite some time to allow the effects to sink deeper and bring about higher outcomes.
Step IV: Impact the whole tub
Move ahead yet again to impact the whole bathtub. This, you will do by repeating the same process above; this time round on the rest of the bathtub. Use more water though to be able to give rise to a thinner cleanser in the case of the stainless steel fixtures and the drain covers.
Step V: Shine the entire equipment
After you are through with that, rinse the tub and the fixtures thoroughly. Next, buff it off with to shine to allow it to sparkle cleanly. To do this, you will have to make use of a soft piece of dry cloth. Pay keen attention that you leave behind no ugly marks as you do so.
#2: How do you clean a badly stained bathtub?
Three steps will allow you to attain that very end. We look into them here below:
Step I: Gather the essentials
Needless to say, you have to start by gathering the essentials. Some of the gears you will need for the job are the white vinegar and lemon juice. You will need them, particularly for your enamel and acrylic bathtubs.
Step II: Apply the ingredients of the tub
At this stage, you apply the ingredients we have spoken of above to the tub. Spray them evenly on the areas of the tub and leave the same to settle for some 10 to 20 minutes. Thereafter, proceed to wipe the stains away by the use of a sponge.
Step III: Shine the tub
Some bathtubs will usually demand that you shine them after use. The porcelain bathtubs are the most affected by this requirement. For them, you will spread out a mixture of hydrogen peroxide and cream of tartar over the stained areas. Leave for 10 minutes before wiping off.
#3: Can I use vinegar to clean my tub?
WHY NOT? Vinegar has potent ingredients and chemicals that do the awesome job of eliminating all forms of dirt and other contaminants that may compromise your comfort and wellbeing. It is worth noting though that the chemical is a bit strong. This calls for caution and care on your part.
Also, you are strongly recommended to dilute the same before deploying it for the use of cleaning your bathtubs. The purpose of this dilution is to diminish the potency in such a way as to guarantee that you won’t be burned with the acidic contents that are abundantly present therein.
To be on the safe side further, you also have to put on the various safety gears. These include the facemasks, aprons, overalls and a pair of gloves. They act to shield your vital organs from direct exposure to and contamination by the harsh acidic contents of the vinegar.
#4: How do you deep clean a bathtub?
Follow these steps to be able to attain that very end:
Step I: Prepare the detergent appropriately
You should start by preparing the detergent you will use for the job appropriately. This entails mixing the mild liquid dish detergent with warm water in the right proportions. Proceed also to mix the water with the soap too! Follow the instructions that are contained in the manual diligently.
Step II: Dip the sponge in the detergent
For all practical purposes, the non-abrasive sponge would be the most suitable for the job. Dip it in the soapy water you have already prepared above. Go ahead to rub it on the entire bathtub so that you may detach the body oils and dirt from off the surface. Alternate this by rinsing the sponge before reapplying further.
Step III: Deal with the grime and stubborn dirt
After eliminating the surface dirt, you have to take a step further to get rid of the grime and stubborn dirt. This will require the use of the baking soda, as it is more potent than the vinegar and other solutions. Make a paste and soak the affected parts for some time.
Step IV: Tackle the Mineral Deposits and Scum
Having eliminated the grime and stubborn dirt, you now have to tackle the scum and mineral deposits. This will naturally require the full-strength white vinegar. Pour the vinegar on these stains and leave to rest for 15 minutes or so. This is to allow for sufficient exposure and impacts.
Step V: Rinse thoroughly
Finish off the exercise by rinsing the bathtub thoroughly with clean water. Use a sponge to eliminate the debris and other residual dirt that has settled on the surface. This may require several passes to be able to obtain the glittering outcomes you badly yearn for. Refill the bathtub thereafter.
#5: How do I clean the bottom of my bathtub?
To cleanse the bottom of your bathtub, follow these steps:
Step I: Scrub out all stains
Start by scrubbing the gentle stains from off the surfaces. Use the hydrogen peroxide chemical or some other equal parts of ammonia and baking soda to do the job. Use a gentle scrubbing brush to eliminate stains from off the tub. Exercise some thoroughness in the process though.
Step II: Apply the mixture and leave to settle
Apply the mixtures we have talked of above to the tub and leave to rest for 5 minutes or so. This is to give it time to settle and deliver the necessary impacts you want. Pour some warm to hot water to eliminate every strain of the dirt from off the surface.
Step III: Rinse out the stains and debris
Now, scrub off the entire tub one last instant. This time round employs soapy water and a sponge to do the job. Then, make several passes to be able to accrue completely clean and immaculate outcomes. You should observe some white sparkling looks after the exercise.
#6: How do you clean a bathtub without scrubbing?
These three steps will enable you to do that:
Step I: Prepare the vinegar
You will have to rely extensively on the vinegar to attain this sacred end. To do this, you will have to heat around a quarter of a cup of vinegar. Then, pour the same to a spray bottle to make it ready for eventual use. Seal the contents in the meantime.
Step II: Introduce some liquid dish detergents
To make the vinegar more potent, you will have to add some liquid dish detergents. The ratio has to be 1:1. This means you will yet again have to pour a quarter cup of the liquid dish detergent in a bottle. Then, you will empty the contents in the spray bottle that contains the vinegar and shake hard.
Step III: Apply the cleaners on the bathtub
This last step forms the core of the cleansing exercise. Spray the mixture on the bathtub evenly. Leave it for quite some time to settle. Then, using some hard brush, scrub off the contents; paying particular attention to the parts that are worse affected. Rinse out with clean and preferably warm water.
#7: Can you put bleach in a bathtub?
WHY NOT? Several advantages accrue from the use of the bleach. Below are but a few of them:
Kills molds and bacteria
Many bleaching agents have potent formulations that work to kill all bacteria, mold, and mildew from off the bathtub. The use of the bleach, it goes, has the impact of making your tub safer and more humane to handle and work with. This is besides bringing about limited side effects.
Eliminates stubborn stains
These agents also have the distinctive characteristic of being able to eliminate extremely stubborn stains with absolute ease. Yet again, their potent formulations have the uncanny ability to remove even those dirt that has accumulated over the years and elusive to the ordinary cleaners. It also takes shorter to yield the ends.
Leaves a sparkling appearance
Lastly, the bleaching agents also leave behind some sparkling appearances. They make the tubs to shine and become truly breathtaking to behold. It is this shine that contributes to the added benefit of aesthetics and décor to your home. This also lengthens the total period of the youthfulness of the tubs.
Conclusion
Our guidance comes to an end there. Having done the much we can, we are now confident that you can now take over and make good use of the information. Going about the issue ought not to be that much of an issue now. You just have to adhere to the instructions we have delivered to move ahead smoothly.
No Comments